The aerator should be installed at the bottom of the tank and as close as possible to the inlet.

The inlet and outlet pipes of the push flow aerator should be equipped with valves. Do not turn on the machine when there is no water or poor water quality to avoid damaging the motor and accessories.

When the suspended solids content in the water is high, filtration equipment should be installed on the inlet pipeline. If a submersible pump is used for liquid supply, a filter screen or filter should be installed in front of the submersible pump.

When the push flow aerator is working, the flow rate and pressure should be maintained; When the content of suspended solids in water is low and the water quality is good, it is advisable to use low flow and low pressure working methods; When the water quality is poor and there are many suspended solids in the water, it is advisable to use high-pressure working methods with higher flow rates.

To avoid downtime caused by blockage and affecting normal operation and service life, it is recommended to regularly clean the filter screen and remove impurities to ensure its outstanding operational function and service life.

In case of power outage or other reasons that prevent normal operation during use, the power switch can be turned off and stopped for a period of time before being restarted.

Article source: Manufacturer of Push Flow Aeration Machinewww.jmyuankekj.com